Ujla Gupta

Senior Lead Engineer,Front Camera-EADAS Customer : HONDA

• Handled main core Module of the Project i.e MEYEM ,CAL,DIAGW in during coreProtocol bringup and did Mobileye SPI Signal Testing with minimal Knowledge Sharing.
• Static analysis performed using Polyspace tool for handled modules .
• Found different techniques logic to Write automated test cases for optimized code by which now highly complex test cases are automated and are also consistent
• Test report preparation and Delivery at SWE4 level with FTQ green on every deliveries
• Decide the Scope for delta loops for SWE4 scope according to the CCB change and code modification
• Internal SWE4 and SWE5 level Test case Review, Requirement review at LLD level and Quality peer review
• Software Integration test development and Execution
• Achieved Automation tests stability(>90%) despite many HW and SW challenges for handled modules.

Senior Lead Engineer, Front Camera-MEB Customer : VW

• Handled main core Module of the Project i.e MEYEM ,CAL, DIAGW and many other modules for interation testing .
• Software Integration tests development and Execution
• Requirement analysis and tests development Proactive to bring status of DR/ITP from orange to Green with Status.
• Development and testing of vTestStudio Automation framework as per need basis(AutoVTS).
• Given traning on AutoVTS to CAIRO engineers while handovering the project to CAIRO.
• Analysis the scope artifact at SWE5 level and tested according to the CCB sheet .

Senior Software Engineer ,PSA, Customer : Nissan

• Software Integration tests development and Execution
• Requirement analysis and tests development
• Proactively initiated automation testing using AutoVTS tools for this project .

Software Engineer , FORD CD6 , Customer : FORD

• CAPL Scripting and simulation Panel creation
• Created additional panels in CANoe environment were helpful to send multiple signals with appropriate values in terms of activating and Deactivating different algorithms with just single click,which was beneficial in saving time and manual effort
• Implemented Functionality in vTestStudio to find and replace DTC IDs at run time, which prevented failure of many Test Cases in all iteration released in CD6 because of the changing nature of DTC IDs, in year 2019 - early 2020 (compatible to find Internal error IDs , Diag Error IDs, including DTC IDs)
• Automation test development and test bench setup
• Software Integration test development and Execution ∠ Requirement analysis and test development

Graduate Engineer Trainee , FORD CD6 , Customer : FORD

• Module testing of SOC modules, Using LDRA Tool (C++)
• Module tests report preparation and delivery.

Graduate Engineer Trainee , ANNOTATION , Customer : AUDI

• Graphical data Analysis (Annotation) using Pylosis label editor.